Board index
Login
SearchMy power went out on my 2001 Chevrolet Camaro Z28 predator tuner. Found out a wire became unconnected from the chip in the OBDII connection case. CONFUSED. The gray wire is soddered to the brown connection spot and the white wire is soddered to the blue connection spot. A green wire is unattached and appears to have been previously soddered to the red connection spot....is this correct? Also the brown wire in the pic I attached appears to have never been soddered to anything, is this true as well?
Thanks, Alex
Sorry for the super big attachment!
Board index ‹ Predator Technical Discussion ‹ Predator GM Gas ‹ OBDII wire connector help
Thu Jul 09, 2015 7:30 pm
Fri Jul 10, 2015 8:46 am
Fri Jul 10, 2015 10:58 am
2014 Camaro SS - 2SS, RS pkg., short-throw shifter, NPP perf. exhaust, BMR strut-tower brace, Cold Air Inductions cold air intake
Mon Jul 13, 2015 10:59 am
OBDII wire connector help
Moderators: mikel, 06MonteSS, Vas@Diablosport, JonDiablosport
4 posts
• Page 1 of 1
Thu Jul 09, 2015 7:30 pm
- Attachments
-
- IMG_1418.JPG (1.61 MiB) Viewed 1489 times
Red 2001 Chevrolet Camaro Z28, SLP intake, SLP Y-pipe, SLP exhaust, Predator custom tune, BMR suspension, Eibach Pro-kit
Fri Jul 10, 2015 8:46 am
yes... it goes to the red connection spot. 
Fri Jul 10, 2015 10:58 am
might as well fix that Brown wire too while you're in there, that one's already breaking off too...
2014 Camaro SS - 2SS, RS pkg., short-throw shifter, NPP perf. exhaust, BMR strut-tower brace, Cold Air Inductions cold air intake
Mon Jul 13, 2015 10:59 am
Made the connection and it works perfect. Never knew where the brown wire was connected to...no evidence of a sodder break. Looks like it was never connected?
Red 2001 Chevrolet Camaro Z28, SLP intake, SLP Y-pipe, SLP exhaust, Predator custom tune, BMR suspension, Eibach Pro-kit
4 posts
• Page 1 of 1